Gamechanger Audio PLUS Pedal II
The PLUS Pedal II's six knobs, the brass pedal and all four mode switches on one page, over USB-MIDI. Every knob sends 14-bit CC, so sweeps are smooth rather than stepped.
Knobs 1 to 3 are Level, Rise and Tone. Knob 4 is the brass pedal as a knob, so the sustain holds wherever you leave it. Knobs 6 to 8 are Resonance, Decay and Layers. Resonance has a centre indent at the pedal's no-harmonics point, with lower harmonics below it and upper above. Layers runs 1 to 10, then Infinite at the top of the turn.
Buttons: Catch mode (Single, Group, All) on 1, the brass pedal as a momentary press on 4, Kill Dry on 6, FX loop position (Post, FX Loop, Pre) on 7 and Hold mode (None, First, All) on 8.
Sends on MIDI channel 1. Checked against the MIDI chart in Gamechanger's PLUS Pedal II manual: every CC and every step label matches.
Tested with the device Somebody has run this into the gear it was made for.
Does this work with your Gamechanger Audio PLUS Pedal II?
Open ROTO-SETUP, select the slot you want to overwrite, then File > Import.
Set this to match your gear and we will change it in the file before you download it.
The layout
Page 1
| Control | Name | Sends | Channel | Feel |
|---|---|---|---|---|
| Knob 1 | LEVEL | CC 8 (14-bit) | 1 | Center indent |
| Knob 2 | RISE | CC 10 (14-bit) | 1 | Center indent |
| Knob 3 | TONE | CC 12 (14-bit) | 1 | Center indent |
| Knob 4 | BRASS PEDAL | CC 14 (14-bit) | 1 | Smooth |
| Knob 6 | RESONANCE | CC 13 (14-bit) | 1 | Center indent |
| Knob 7 | DECAY | CC 11 (14-bit) | 1 | Center indent |
| Knob 8 | LAYERS | CC 9 (14-bit) | 1 | Center indent |
| Button 1 | CATCH MODE | CC 15 | 1 | Latching |
| Button 4 | BRASS PEDAL | CC 14 | 1 | Momentary |
| Button 6 | KILL DRY | CC 17 | 1 | Latching |
| Button 7 | FX LOOP | CC 18 | 1 | Latching |
| Button 8 | HOLD MODE | CC 16 | 1 | Latching |
Details
- Made for
- Gamechanger Audio PLUS Pedal II
- Works with
- Roto-Control
- Panel used
- 7 knobs, 5 buttons
- MIDI channel
- 1
- Added
- 2026-10-26