Arturia Rev PLATE-140 (stereo)
Stereo only. This setup was exported from a stereo instance of the plugin, and the Roto will not load it on a mono track.
Page 1: Drive, Plate Model (three detents) and Decay Time (17 detents) on knobs 1 to 3, Width on knob 7, and Dry/Wet on knob 8 with a centre indent.
Page 2: Pre Delay, HP Filter, modulation Pre/Post and amount, then the post EQ's low shelf gain and frequency and high shelf frequency and gain on knobs 1 to 8, with Modulation on/off on button 3 and Post EQ on/off on button 5.
The author reports that the Roto does not follow when you change preset inside the plugin, and that the same goes for every Arturia plugin. Made in Logic Pro with the AU.
Tested with the device Somebody has run this into the gear it was made for.
Does this work with your Arturia Rev PLATE-140?
Open ROTO-SETUP with the Roto in PLUGIN mode, then File > Import.
The layout
Page 1
Page 2
| Page | Control | Name | Feel |
|---|---|---|---|
| 1 | Knob 1 | Drive | Smooth |
| 1 | Knob 2 | Plate Model | 3 detents |
| 1 | Knob 3 | Decay Time | 17 detents |
| 1 | Knob 7 | Width | Smooth |
| 1 | Knob 8 | Dry/Wet | Center indent |
| 2 | Knob 1 | Pre Delay | Smooth |
| 2 | Knob 2 | HP Filter | Smooth |
| 2 | Knob 3 | Pre/Post Mod | 2 detents |
| 2 | Knob 4 | Mod amount | Smooth |
| 2 | Knob 5 | Lo Sh Gain | Smooth |
| 2 | Knob 6 | Lo Sh Freq | Smooth |
| 2 | Knob 7 | Hi Sh Freq | Smooth |
| 2 | Knob 8 | Hi Sh Gain | Smooth |
| 2 | Button 3 | Modulation | Latching |
| 2 | Button 5 | PostEQ On/Of | Latching |
Details
- Made for
- Arturia Rev PLATE-140
- Format
- AU
- DAW
- Logic Pro
- Works with
- Roto-Control
- Panel used
- 13 knobs, 2 buttons, 2 pages
- Firmware tested
- 3.2.1
- Added
- 2026-10-19